1. /u0039/u0031/u0031/u67E5/u8BE2/u00B7/u82F1/u8BED/u5355/u8BCD

1. 串音：(二)双绞线顾名思义导线须对绞,而对绞的目的就是要减少杂音(Noise),串音(Crosstalk)等干扰,因为当线上的电流流动时会产生电磁场,因而干扰其他导线,若把正信号和负信号对绞,则两者产生之磁场互相抵消,

2. 道间串扰：我们最关心的攻击是干扰攻击(即用攻击信号来干扰合法的网络信号,可能导致服务降级或拒绝服务)以及利用设备道间串扰(Crosstalk)的攻击. 设备道间串扰是信号从光纤设备的一部分泄漏到另一部分时发生的一种现象,在绝大多数现代光纤设备中普遍存在,

1. The crosstalks between the channels of TDM were theoretically analyzed, and the simulation technique was used to investigate the relation of crosstalk to such factors as the extinction ratio of optical switch and the channels multiplexed in the TDM array.
    对时分复用系统中通道之间存在的串扰从理论上进行了深入分析，并运用仿真方法研究了系统中的串扰与光开关消光比、复用通道数等因素的关系。

2. crosstalk

2. May 4, 1920. Zhou Enlai, who is in prison in Tianjin spent: Over the past year and current affairs Review; on the fire floor, the report of Zhao; and evening entertainment, including Chinese music I played (because of his non-musical instruments), comic opera, crosstalk, Kanto drums, storytelling, magic, fragments of Chinese drama, etc., Zhou Enlai presided over the evening and performed a cappella.
    年5月4日。周恩来等人在天津狱中是这样度过的：一年来时事与工作回顾；关于火烧赵家楼的报告；以及晚间的娱乐活动，包括口奏中国音乐、滑稽戏、相声、关东大鼓、评书、变戏法、中国戏剧片段等等，周恩来主持晚会并表演了清唱。

3. Passive protection absorbs substrate currents through deep well and biased guard rings surrounding power devices to decrease crosstalk between power devices and low voltage circuits.
    无源保护结构主要是通过设置环绕功率器件的深阱和偏置隔离环来收集衬底电流，从而减小高压功率器件对低压电路的串扰。

4. crosstalk的反义词

4. We investigate the effect of losses on the delay and crosstalk of the interconnects. The standard of high-loss and low-loss is analyzed.
    我们考察了损耗对互连线信号传输的影响，包括延时和串音等，并分析了高损与低损的界分问题。

5. It can deal with arbitrary rectilinear shape and also has the following features: compaction-oriented, allowing pre-routed nets and obstacles, allowing reserved layer mode or unreserved layer mode, supporting stacked via and carrying out via minimization as part of routing process; critical nets being prior to be routed and crosstalk being taken into consideration.
    并可支持严格分层模式和非严格分层布线模式，可支持连接非相邻布线层的通孔，可在布线同时进行通孔优化，并尽量避免并排相邻的通孔出现，还可对关键线网的布线优先考虑，可进行关键线网的串扰优化。

6. Among them, crosstalk noise caused by coupling capacitance is the most dominating signal integrity problem on chip.
    这其中，由耦合电容引起的串扰噪声是芯片内部最主要的信号完整性问题。

7. A method predicting crosstalk coupling between interconnecting wires with artificial neural networks is proposed.
    提出应用人工神经网络对互连导线间串扰问题进行预测的方法。

8. Which influenced most is crosstalk. Crosstalk noise caused by coupling capacitance will result in a grate deal of timing violation and logical error.
    其中，对于深亚微米IC影响最大的是串扰，由连线间耦合电容引起的串扰噪声会产生大量的时序违规、逻辑错误。

9. In this paper, a more accurate ABCD model with modified mutual inductance is introduced. Finally, crosstalk coupling noise of interconnects in LTCC technology is analyzed using ADS simulation to verify the improved ABCD model.
    该文根据互感的基本定义，修改了原模型中互感的表示方法，提出了一个新的ABCD矩阵级联模型，对LTCC工艺互连线的串扰耦合噪声进行分析，并将得到的ABCD模型分析结果与ADS软件的仿真结果对比，验证了改进的ABCD模型的准确性。

10. As specified for use in Token Ring network installations, STP reduces electrical noise within the cable such as pair to pair coupling and crosstalk.
    指定使用在记号环网路安装，STP减低缆线内的电子杂讯，诸如对到对的耦合和串音。

11. In the algorithm, the priority queue concept and the rip-up and reroute strategy are combined to control crosstalk noise caused by interconnect coupling capacitance.
      该算法采用优先队列同拆线重布策略相结合的方法，控制由互连线耦合电容引起的串扰噪声。

12. The crosstalk coupling voltage is analyzed through adding the trapezoidal wave with 18 ns level rising edge at the port of the generator line.
      结果显示：仿真波形的振荡与幅度和实验结果的振荡与幅度基本一致，并且在匹配阻抗下其仿真精度大于SPICE仿真精度。

13. In communications, the aggregate crosstalk from a number of interfering sources.
      在通信系统中，由许多干扰源的串音引起的噪声。参阅crosstalk。

14. In today's VLSI designs, the growing of crosstalk effects causing chips to fail or suffer from low yields has become the important issue.
      在现今的超大型积体电路的设计中，随之成长的杂讯干扰现象而造成晶片失败或良率降低，已变成很重要的课题。

15. The key problems include crosstalk between signals, reflection on transmission line and impedance matching.
      这些问题包括信号之间的串扰、传输线上的反射、阻抗匹配等。

16. This method relative hybrid method generally have the following advantages: First, the performance can be greatly improved, because parasitic capacitance and crosstalk phenomenon can be significantly reduced; second, hybrid method requires sophisticated technology to reduce packaging Sensor Interface affected, and monolithic integration requires packaging technology is relatively simple and therefore, lower cost sensors; third, monolithic integrated sensor array sensor technology is the need to overcome the array sensor and external decoding circuit an effective interconnect bottleneck; Fourth, the development of monolithic integrated mixed development of MEMS products than MEMS products for a short time, and to develop low cost.
      这种方法相对混合方法总的来说有如下优势：第一，性能能得到很大的提高，因为寄生电容和串扰现象可以显著减小；第二，混合方法需要复杂的封装技术以减小传感器接口的影响，而单片集成方法需要的封装技术相对简单，所以，降低传感器成本；第三，单片集成传感器技术也是阵列传感器的需要，是克服阵列传感器与外围译码电路互连瓶颈的一种有效方法；第四，开发单片集成MEMS产品比开发混合MEMS产品所需的时间短，而且，开发成本低。

17. crosstalk是什么意思

17. I urge you, Jiusecaiqi-of-jun, Chihepiaodu Zhan Shen Mo, Mo Shier put it into the comic dialogue, listening to two crosstalk on the San Sanxin.
      我劝诸位，酒色财气君莫占，吃喝嫖赌莫沾身，没事儿就把那相声大会进，听两段相声就散散心。

18. The twisted structure, canceling interference to some degree, can enhance the immunity against crosstalk and radiated emission.
      所以为了提高高速电路的信号完整性，差分传输线被越来越多的运用于高速数字电路，比如D V I，U S B和IEEE1394

19. Due to attenuation, crosstalk occurring further away from the transmitter creates less noise on a cable than NEXT.
      由於衰减，发生在远离传送器的串音产生的缆线杂讯是比NEXT少

20. Crosstalk effect between different polarization channels of TRM is analyzed, and the error term is given.
      分析了由极化通道间隔离度不理想导致的定标误差，给出了误差的解析表达式。

1. the presence of an unwanted signal via an accidental coupling

    Synonym: XT